Sales

Home

Rentals

Sales

Computers

Download Drivers

Product Manuals

FAQ's

	Frequently Asked Questions
	CP - 100PRO		SE - 200PRO
	DAC - 10		SE - 800
	DAC - 100		VDR - 3000
	DV Bank

 SE - 800

Front

Q: What is the final image height in pixels if we mix an analog image 486px with a DV image 480px?

A: The final image resolution will be 480px in height.

Q: Can you mix between DV sources and Analog sources?

A: Yes, The SE-800 can actively switch between any of the four input sources.

Q: Is there a charge for firmware updates?

A: There is no charge for the firmware.

Q: Can the SE-800 be controlled remotely with anything other than
the RMC-90.

A: Yes, the RS232 protocol is available on this web site.

Q: How do you address DV audio delay?

A: DV Audio delay, like chroma, is set for each of the assigned inputs. If you change the assignment of the input from DV to S-Video, you may want to reset the audio delay.
There is a no charge firmware update for early SE-800DV purchasers.

Q: What Character Generator choices exist?

A: Because the SE-800 accepts a SDI based Character Generator, the quality will be excellent; and most products are expensive.
We have found that the DECKLINK-PRO SDI card from
www.blackmagic-design.com works very well. HOWEVER, at this time
ONLY the MAC software has been implemented by Black magic-design.

Q: Is the carrying case suitable for use as a shipping case?

A: The carrying case is not suitable as a shipping case.

Q: I am using DV camera's for a video feed and I am using an external audio mixing board. How do I get the audio and video to synchronize?

A: You cannot adjust Audio/Video synchronization when using the Aux input. To use sound from a audio mixer, you must connect the mixer to one of the audio input channels on the SE-800. You will then need to disable the DV audio stream from the SE-800.
Please see the diagram below:

Using on external mixer
	Separate the DV audio from the DV video so you can use an external audio mixer. Connect the mixer input to channel A, B, C or D but not to aux inputs 1. Press the INPUT FORMAT button. To select channel A, B, C or D
	2. On the EFFECTS number pad, type "01" and then press the "ENT" key. 3. Press the "SPD" key to toggle "N" and "Y" ("Y" enables the DV audio on each DV input "N" disables the DV audio on the DV input and enables the analog line inputs.) 4. Press the INPUT FORMAT button to exit and save your current selection.
Note: Connect the output from your mixing board to channels A, B, C, D, only or your audio and video will not be in SYNC. (Do not connect it to the AUX input on the mixer.)

Home . Rentals . Sales . Computers . Consulting

What's New . Press Releases . Road Map . Email

Press Releases