Sales

	DAC–5 converts SDI video and AES/EBU audio to and from FireWire DV audio/video.
	Unit Dimensions/Weight Width: 8 inches, 205 mm, Depth: 9.8 inches, 250 mm Height

	Select SDI or DV Input

	Select 12 Bit or 16 Bit Audio
	Adjusts the audio encoding frequency during an analog capture. Two channels AES/EBU Ch1/Ch2 In and Out thru the D–Sub 15 pin jack

Dip Switches

Dip switches control the FireWire frequency settings on the converter, NTSC/PAL video standards and DV auto selection.

Dip Switch Setting for Mode Select:
Note 1: Mode DIP switch (Reboot the DAC–5 if you change a DIP switch)
S1 PAL or NTSC (PAL-ON, NTSC-OFF)
S2 7.5 IRE/0 IRE (0 IRE-ON, 7.5 IRE–OFF) (NTSC mode only)
Note 2: 0 IRE is most often used in Japan 7.5 IRE is used eleswhere.
S3 Locked Audio Mode
S3 OFF: Locked Audio
S3 ON: Unlocked Audio
S4 & S5 for NTSC and PAL Video System
S5	ON	S4	ON	MAC OS
			OFF	Windows 2000 and Windows 98
S5	OFF	S4	ON	Windows XP and Windows ME
			OFF	Camera
S6 Factory setting (OFF), please do not change

	Analog: Video Monitoring
	Monitor your video in composite, Component or S–Video.

	Analog: Audio
	There are two channels (RCA connectors) to monitor Audio output RCA terminals (unbalanced). For balanced audio, use the BAC–03 audio

	Analog: Blackburst Output
	Blackburst Output Use

Digital: DV I/O

	Digital: Audio
	Two channels AES/EBU Ch1/Ch2 In and Out thru the D–Sub 15 pin to BNC adaptor.

Digital: SDI I/O

 Controls: Audio I/O

All of the cables remain attached.

Pin 1	XLR positive in
Pin 2	XLR positive out
Pin 3	BNC in (signal)
Pin 4	Toshilink in (optional)
Pin 5	Toshilink in + 5V power supply (optional)
Pin 6	Ground
Pin 7	Ground
Pin 8	BNC in ground
Pin 9	BNC out ground
Pin 10	Ground
Pin 11	XLR negative in
Pin 12	XLR negative out
Pin 13	BNC out (signal)
Pin 14	Toshilink out (optional)
Pin 15	Toshilink out + 5V power supply (optional)
Note: Toshilink is optical S/PDIF interface

	Accessories: Balanced/Unbalanced Audio Box
	(Front and rear views shown) Use this box to input/output balanced audio used in Betacam Decks, audio mixers, etc. It’s also a good addition to any video tech’s tool box. Part No. BAC-03

	Accessories: Rackmount for One DAC–5
	Rackmount for Two DAC–5's Mount two DAC–5's in a standard rack. 2U high. or, mount one DAC–10 and one DAC–5. The DAC–10 converts between DV and Component.

	Accessories: Rackmount for Two DAC-5s
	Rackmount for one DAC–5. Mount one DAC–5 in a standard rack. 2U height.

Home . Rentals . Sales . Computers . Consulting

Press Releases