Improve
Video Signal Quality – Get clean video captures
Most video camcorders produce relatively unstable, synchronized
signals. This can cause poor video image quality when capturing
to your PC or recording to another deck.
The TBC-100 corrects this by replacing all sync signals from the
video source with new signals.
KEY FEATURES
Self contained - stand alone.
Compatible with VHS, VHS-C, S-VHS, S-VHS-C Video 8, Hi 8 and
Digital 8 format.
Digital frame synchronization with full frame memory.
Re-generates all synchronization signals to stabilize the
video.
Auto-detects NTSC or PAL format.
Wide bandwidth-4.5MHz in Y/C and 3.5MHz in composite.
8-bit video resolution–4:2:2 sampling rate DP < 1 Degree–DG
less than 2%.
Low noise - S/N ratio > 50dBBuilt in DA with 4 outputs.
SPECIFICATIONS
Inputs
Y/C Video (S-Video) 4-pin 75 ohm DIN connector (1)
Composite video 75 ohm RCA connector, Level: 1.0VP-P (1)
Stereo Audio RCA Connectors, Impedance: 100K ohm (1)
Outputs Y/C Video (S-Video) (4)
pin 75 ohm DIN connector (4)
Composite video 75 ohm RCA connector, Level: 1.0VP-P/Unity
Stereo Audio RCA Connectors, Impedance: 1K ohm, Level: unity(4)
General Frequency response S-Video 4.5MHz +/- 3dB
DG, DP +/- 2%, 1
S/N Ratio > 50dB
Component Y.U.V. 4:2:2 8-bit, Y: 13.5MHz
Single channel full frame Time Base corrector
Auto Detects NTSC and PAL signals
Power requirement DC 12V, 1.2 amps
Ambient Temperature range 32’-131’F (0’-55’C)
Ambient Humidity < 90%
Weight 7 lbs
Accessories Y/C (S-Video), Composite (RCA) Cables
DC 12V 1.2 amp supply (110V or 220V)
INSTALLATION DIAGRAM
FRONT AND REAR PANEL CONNECTION
1. Power LED, LED will
light up when power is on.
2. Stereo audio, S(Y/C)
video, and composite video input jacks.